AboutUs - Factory Tour

...revolutionizing the way the world unwinds
Welcome to the Pacific Hot Tub Factory Tour. Please click
on the picture to view the larger image and caption.

The first step in the process is to vacuum form the acrylic shell.
The underside of the shell is sprayed with layers of Vinyl Ester and fiberglass to create a watertight vessel and insure structural integrity.
Each layer is hand rolled to remove air pockets and compress the fiberglass.
Once the fiberglass has cured the edges of the tub are trimmed.
Holes are then drilled for the jets and plumbing fixtures.
The edges are ground to ensure a flush fit with the plumbing components.
The jets and other attachments are fitted to the shell.
The plumbing is then attached to the fittings.
The 2x4 treated frame is attached to the shell.
The control module, heater and other electronics are then installed.
The hot tub is then wet tested to insure trouble free operations.
The Cedar or Cedarlite synthetic skirt is then attached.
The space in between the skirt and the shell is then fully foamed which not only insulates but also reduces noise and plumbing vibrations by supporting the plumbing components.
The hot tub is then checked by the quality control team one last time for any imperfections.
And then your Pacific hot tub is ready to be shipped directly to you!

Pacific Hot Tubs in Europe - Mistral

Home | About Us | Titanium Series | Commercial Series | Innovation | Testimonials
Customer Support | Contact Us | Find a dealer | Dealer login | Site map

Pacific Hot Tubs
13025 80th Ave, Surrey, B.C V3W 3B1
TEL: (604)591-1991 FAX: (604)591-1772
Toll free: Eastern: 1-800-707-5788 Western: 1-800-263-7727
infomail@aberhottubs.com